 |
 |
 |
 |
| Section | Discription |
|---|---|
| CASE 1 | A good side view of the case |
| CASE 2 | A look at the complete synthesizer |
| CASE 3 | Makeing the sides |
| CASE 4 | Connecting the sides |
| CASE 5 | Makeing the back |
| CASE 6 | Cover the sides |
| CASE 7 | Connecting the bottom |
| CASE 8 | Mounting the panel |
| PANEL 1 | A look at the panel |
| PANEL 2 | The PC-Board hinge open |
| PANEL 3 | The PC-Board hinge closed |
|
|
Make two ends. One left and one right handed. Then make a partial left angle for the bender box.
|
Add a base angle across the front and a flat bar across the back of the keyboard. Then add another small angle to form the bender box.
|
Add a flat bar to the bottom. Bend a piece of sheet metal to fit the back.
|
Cut a piece of sheet metal for the sides.
|
Bend a piece of flat bar then add it to complete the bottom. Cut a piece of sheet metal to fit the bottom.
|
Mount the panel to the top of the case.
|
A look at the front of the panel.
|
The panel is designed with a hindged flat bar to mount the pc-boards on this allows easy wiring.
|
Once Wiring is complete the hindge is closed and secured.
|